DALI Dimmable LED Driver 60W 24V

DALI Dimmable LED Driver 60W 24V

POS DALI 2 dimmable LED driver. Decent 60 Watts of power is enough for example for 4,5 meters of 12W 12V COB LED strip. This LED driver is DALI 2 (Digital Addressable Lighting Interface) and PUSH-dim adjustable. For controlling Dali you must have Dali system compatible light dimmers and for example KNX or similar automation system. Known manufacturers do have compatible light dimmers available. For example ABB, Ensto, Schneider and many other brands used here in Finland.

If you would like a remote controllable LED dimmer, you will not need this driver. If you would like an LED dimmer that is remote controllable, a suitable LED driver in that case is a normal non-dimmable LED driver where the dimming happens after the driver. In non-dimmable drivers there is no mention of triac, dali or other dimming techniques that would happen on the front side of the driver. For non-dimmable drivers there are several good LED dimmers and those you can find in our LED dimmers category.

Installing a dimmable LED driver

This LED driver is suitable for example for 12V DC LED strips, 12 DC LED downlights, 12V DC LED spotlights, etc. Enough power output for example for 4,5 meters of 12W COB LED strip. The height of the LED driver is 21.3 mm and it is a SLIM series LED driver. Regarding safety, this driver has a short circuit protection, overload protection and overheat protection. Out of these the fault and overload protection function with a power cut principle. It means that in a problem situation the LED driver will start to cut the power and makes the lights blink. Power cut continues until fault has been fixed. Overheat protection cuts the power from 12V side –> lights turn off. Lights can be turned on by turning the power back on. The protection works the same way in other high quality LED drivers as well. The driver cools itself with the surrounding ventilated air. So it is recommended to install in such a place where the warm air gets to mix with surrounding air.

Sufficient LED driver output

Max power output of this DALI 2 LED driver is 60 Watts and operating voltage 24 Volts. When you’re thinking about a suitable driver for your LED project, it is recommended to pick a slightly more powerful LED driver than what the maxium load is going to be. Here you can check out a great blog post about choosing LED drivers . The output of this driver is enough for e.g.:

Max ca.11 meters of 4,5W LED strip
Max ca. 4,5 meters of 12W COB LED strip

 

Compatible tested dimmers:

• No tests

Benefits:

• flicker-free dimming
• Smooth adjustment
• Slim design
• Overload protection
• Overheat protection
• Fault protection
• Full scale dimming 0% – 100%
• 10% minimum load
• Safe TUV-CE, RoHS

Applications:

• 24V LED strips
• 24V LED downlights
• 24V LED spotlights
• 24V LED modules
• 24V LED spots

 

Dimensions and coupling instruction:

The general safety distance from LED driver to surrounding materials is 25 mm above and to the sides. This DALI 2 LED driver belongs to SLIM series and its height is only 21.3 mm, width 30 mm. There is quite a bit more length instead, 361.5 mm. Make sure whether or not the driver will fit through the mounting hole. If there is a place for the driver near a service hatch then the problem is easy to solve.

 

 

DALI 2 coupling

 

PUSH DIM coupling