CRI90 LED Strip Silicone Tube 3000K 4.8W 12V 2.5 m
High CRI Ledtek LED strip for example for sauna or terrace. CRI +90 and blue light wavelength over 460 nm. Due to this fact the light will not put a strain on your eyes unlike the lower wavelengths. This LED strip is applicable to locations where “mood lighting” is required. The colour of the light is warm white and high Colour Rendering Index (CRI) makes it an appealing light source. It makes you feel comfortable to spend time in that space. This is a 2.5 meter strip that has 2 meters of cable on one end.
- Mood lighting
- Indirect lighting
- For stairs behind the hand railing or steps.
- Cabinet lighting
- Curtain cases
- Drawer lighting
- Suitable for sauna and bathroom. In sauna recommended maximum height is back board of sauna benches.
- Suitable for terraces
Installing and cutting LED strip
In addition to LED strip you will need an LED driver and optionally a dimmer. To make installing easier there’s two meters of cable on one end of the LED strip. The length of the strip is 2.5 meters from which you can cut the length that suits your needs. Cut points every 5 cm. You don’t necessarily need connectors or soldering. In case you do, pick 8 mm connectors. In the package there are two silicone endpieces included. Use the endpiece + silicone to seal the end of the tube if you cut the strip. The strip is delivered with one end open. The reason why we do that is when we cut the strip from a 5 meter reel it is not practical to seal the 2,5 meter cut point when in practice most of the times the strip is cut during installation anyway. This makes processing the product for delivery faster when you don’t have to wait for the silicone sealing to dry.
Usually it is recommended to use aluminum profiles for LED strip installations. For this strip it is optional, however, because the strip will not warm up considerably. For example 1715 aluminum profile goes well with this LED strip. On the strip there is a 3M tape but the strength of the tape is probably not that good in damp/wet spaces. In addition to tape you may use gluing compound or mounting clips.
LED driver for LED strip
The load of the strip is 2,5 x 4.8W = 12 Watts. For this we have available
Coupling the POS driver can be done directly to the screw connectors. Coupling the GLP driver can be easily done with Wago2 connectors. You will need two Wago connectors between the driver and the strip and 3 pcs on the primary side. Electricians often have Wagos, but if you want all beforehand, we have them available.
Contents of package
1 x LED strip 2.5 m
2 x silicone endpiece